Basler BIP2-DXXXXc-dn Instrukcja Użytkownika Pobierz pdf (Strona 87)

AW00101507000 Factory Default Button

Basler IP Fixed Dome Cameras 83

4 Factory Default Button

A factory defaults button is available on the side of the camera as shown below. The factory defaults

button is especially useful if you have enabled user management on the camera and you can no

longer remember your administrative password. Using the button resets all of the camera’s

parameters to factory defaults. ALL STORED SETTINGS - INCLUDING THE NETWORK

SETTINGS - WILL BE LOST.

Depending on how your network is configured, you may not be able to access the camera

via your web browser after you set the camera to the defaults. If this is the case, use the Basler

BIP Finder software to locate your camera on the network and to connect to it as described in the

Basler IP Fixed Dome Camera Installation Guide.

To use the factory default button:

1. Look into the hole labeled "Factory Reset" on the side of the camera base and locate the

default button.

2. Obtain a plastic stylus or similar non-conductive device that you can use to press the button.

3. Remove power from the camera.

4. Press and hold the default button.

5. Apply power to the camera while continuing to hold the button pressed.

After you have applied power, you will notice that the Status LEDs begin to flash in an alternating

pattern.

6. Release the default button.

7. When the alternating flashing stops, wait approximately one minute for the camera to finish the

reset process and to reboot.

Status

LEDs

Factory

Default

Button

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 127 128

Komentarze do niniejszej Instrukcji

Brak uwag