Basler BIP2-DXXXXc-dn Instrukcja Użytkownika Pobierz pdf (Strona 90)

Terminal Blocks and Audio Connector AW00101507000

86 Basler IP Fixed Dome Cameras

The assignments for the wire fixing holes in the main terminal block are as shown below and

explained in Table 3 on page 87.

Fig. 10: Main Terminal Block

The main terminal block is a push-in type of connector. Either solid or stranded wires can be

inserted into the wire fixing holes in the terminal block. A wire can be removed from a fixing hole by

pressing the release tab above the hole and pulling on the wire.

Wires inserted into the fixing holes must have a minimum cross section of 0.2 mm

2

(AWG 24) and

a maximum cross section of 1.5 mm

2

(AWG 16).

8 mm (5/16") of insulation should be stripped from the end of a wire before it is inserted into a fixing

hole.

Basler recommends that connections to the I/O ports be made with shielded cable

and that the cable shields be connected to ground. If you are unable to connect

the cable shields to ground or if you use unshielded cable, the maximum length of

the I/O port connections is limited to 10 m to avoid electromagnetic interference.

Wire

Fixing

Holes

Release

Tabs

(Present on outdoor

dome cameras only)

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 127 128

Komentarze do niniejszej Instrukcji

Brak uwag